z step not working with lightburn software

Jog Distance is 0, please reset - This error appears to be a bug in the KT332N Ryxon/Ruida Controllers running DSP firmware 23.01.06. MACHINE PROTECTED WORK PAUSED - This error can be caused by a faulty lid sensor or wiring. Depending on the design, the error may not always occur immediately. Increasing the acceleration or reducing the speed will both reduce the amount of overshoot space required.

If the design is too close to the sides of the machine, the overshoot distance may result in crashing the machine. When the laser is engraving, it may require extra space on the sides to get up to speed before the engraving starts, and to slow down and reverse after the engraving is finished. This error message refers to Overscanning or Overshoot. Need more overshotting or larger acceleration (grammatical error intended) - Like the NOT ENOUGH EXTEND SPACE error, t his error occurs when the design is too close to an edge of the bed. NOT ENOUGH EXTEND SPACE - This error occurs when the design is too close to an edge of the bed to allow room for the head to stop and reverse. It may a lso occur if the design is larger than the bed. Y Slop over - This error occurs when there isn't enough room for the design to fit on the bed starting from the origin. X Slop over - This error occurs when there isn't enough room for the design to fit on the bed starting from the origin. Issues W ith Specific Error Messages.Ĭooler Error 1 Worked Paused - This error occurs when the chiller isn't on or water is not flowing through the water sensor connected to the Ruida panel. See the page Software Installation for information on backing up your files.Ī.

WARNING: BEFORE making ANY of the changes below, be sure to make a backup of you settings file(s).

Z step not working with lightburn software